UFESA Onyx BS2400 Manual De Instrucciones página 15

AF-Manual-Batidora-UFESA-BS2400 Onyx.pdf
INDICATOR LIGHT INSTRUCTION
1. Quick double click on the O / I switch; the blender will start running with a white indicator light; The opera-
ting time is 45 seconds with automatic stop.
2. When you are charging batteries through the USB connection, the indicator light will be red until charging
is complete. When the charge is complete the light will turn white.
3. The red light will flash if you try to start the blender without the bottle or if you have placed it incorrectly,
indicating that it is "not working".
4. When the blender stops due to a disorderly rotation of the food, the red and white lights will flash ten times
alternately.
5. The red indicator light will last for five seconds when the blender is almost out of power or completely out
of power.
6. When water is added to the lower blades, the machine will automatically stop to protect itself after five
seconds of operation, at that moment the red indicator light will flash three times.
INSTRUCTIONS FOR USE
It is recommended to use 200ml of water for every 100g of food.
Do not fill more than 2/3 of the bottle for a better mixing.
C
M
1. Cut the fruit into small pieces (1.5 cm to 2 cm approximately), peeled and pitted.
Y
2. Add the fruits and water or milk to the bottle.
3. Press and hold the O / I button for two seconds to start.
CM
4. After 45 seconds, the mixer will stop automatically.
MY
Note: If the food is too big or too hard, and the blade is stuck, the product can be inverted, and quick double click
CY
on the O / I switch. When the blade rotates at high speed, put the product in the right position, and the product can
CMY
be used normally
K
¿HOW TO CHARGE THE BLENDER?
Make sure that the mixer is properly charged, the maximum charging time is 3 to 5 hours for an average of
15 - 20 uses.
The combined capacity of the battery is approximately 5200mAh, and it can be recharged via USB through
the adapter cable to a powerbank, laptop or desktop computer, USB car charger, etc...
1. Put the USB cable into the socket on the base.
2. Connect the other end of the cable to a powerbank, USB computer, etc.
Note: When the red light appears it means the blender is charging, when it finishes the white light will appear.
Do not turn on the blender while charging.
If the blender is charging, but the light does not work or cannot be charged, please try to change the charging
cable, if it still does not work, please contact customer service to solve the problem.
In order to ensure safety, please do not disassemble the blender without authorization, if there are any
abnormal, please sent to the company around the service center or agencies, will be maintenance by
qualified maintenance sta .
15 29/12/20 15:05
15