General Safety Instructions - Safco TASK MASTER 5113 Instrucciones De Ensamblaje

CHAIR ADJUSTMENT INSTRUCTIONS
To maximize the ergonomic benefi ts of this chair, it is essential to understand how the controls function and how they affect your posture.
ADJUST THE
HEIGHT RANGE:
The front lever under the seat on the left side
pneumatically adjusts the height of the seat over a
range of about 8". The proper height should
be determined by a combination of variables:
the height of the work surface, the task to be
performed and your body size. Typically, the chair
should be high enough so your arms form
a 90 angle at the elbow or slightly greater.
o
This allows for better circulation in the shoulders
and neck area and also reduces the amount of
fatigue in the forearms and hands. The feet should
lie fl at on the ground or footring. To help insure
good posture, maintain a 90
the knees.
MAINTENANCE
The pneumatic lift in the Cylinder is permanently
lubricated at the factory and needs no further
lubrication. NEVER LUBRICATE THE
PNEUMATIC LIFT. Do not remove clip from
bottom of Cylinder. Contact Safco immediately if
clip is missing or damaged. Clean polyurethane
seat and back with soap and water. To repair
small cuts in polyurethane, apply a few drops of
quick drying glue into the cut and press the sides
together until the glue sets.
100511337: 2 of 6; Rev A; Rev Date 19-SEP-2016
ADJUST THE
BACK HEIGHT:
The backrest height
adjustment lever is behind
and below the seat. By sliding
the backrest assembly up or
down, you adjust the height
of the back, which has a
lumbar support curve to it.
Sit centered on the seat. The
curve in the backrest should
fi t into the small of your back.
This will reduce the pressure
on the spinal discs, especially
angle at the bend of in the lumbar area.
o
ADJUST THE
BACK ANGLE:
The back angle adjustment
lever is the rear one on the
left side, under the seat. The
22 angle adjustment of the
o
backrest is especially critical
for work tasks that require
leaning forward. Pull up on
the lever and allow the surface
of the backrest to support
the upper body weight by
positioning it to
the natural curve of the spine.
Press down on the lever to
lock into place. The backrest
hinge should tilt freely, to help
prevent twisting of the spine.

GENERAL SAFETY INSTRUCTIONS

Do not stand on seat.
Chair must be on level surface to ensure proper
stability.
Only use chair when fully assembled.
Never use chair if it does not perform according
to this sheet or warranty may be void.
Immediately report any problems to Safco
and always give the manufacturer's date code
information from the label under the seat.
Safco Products Company, New Hope, MN 55428
ADJUST THE
SEAT ANGLE:
The seat angle adjustment
lever is the one on the right
side, under the seat. The
seat tilt is important for work
tasks that require leaning
foward. The 10 tilt allows you
o
to lean foward without extra
pressure under the thighs.
Lift the lever and shift your
weight forward until you fi nd
a comfortable position, then
release the lever to lock into
place.