General Safety Instructions - Safco TASK MASTER 5113 Instrucciones De Ensamblaje

CHAIR ADJUSTMENT INSTRUCTIONS
To maximize the ergonomic benefits of this chair, it is essential to understand how the controls function and how they affect your posture.
ADJUST THE
HEIGHT RANGE:
The front lever under the seat on the left side
pneumatically adjusts the height of the seat over
a range of about 8". The proper height should
be determined by a combination of variables:
the height of the work surface, the task to be
performed and your body size. Typically, the
chair should be high enough so your arms form
a 90 angle at the elbow or slightly greater.
o
This allows for better circulation in the shoulders
and neck area and also reduces the amount of
fatigue in the forearms and hands. The feet
should lie flat on the ground or footring. To help
insure good posture, maintain a 90
bend of the knees.
Thank you for purchasing this Safco
product. In order to make any warranty
claim, it is necessary to complete and
return the enclosed warranty
registration within 30 days of purchase.
Due to continual upgrading of our
products, photographs or illustrations
may not reflect actual (exact)
appearance of product.
Safco Products Company
9300 West Research Center Road
New Hope, MN 55428
Fax: (612) 536-6777
5113-37MP: 2 of 6; Rev. 3; 9/06
ADJUST THE
BACK HEIGHT:
The backrest height
adjustment knob is behind
and below the seat. By sliding
the backrest assembly up or
down, you adjust the height
of the back, which has a
lumbar support curve to it.
Sit centered on the seat. The
curve in the backrest should
fit into the small of your back.
This will reduce the pressure
on the spinal discs, especially
angle at the in the lumbar area.
o
ADJUST THE
BACK ANGLE:
The back angle adjustment
lever is the rear one on the
left side, under the seat. The
22 o angle adjustment of the
backrest is especially critical
for work tasks that require
leaning forward. Pull up on
the lever and allow the
surface of the backrest to
support the upper body
weight by positioning it to
the natural curve of the spine.
Press down on the lever to
lock into place. The backrest
hinge should tilt freely, to help
prevent twisting of the spine.
MAINTENANCE
The pneumatic lift in the Cylinder is permanently lubricated
at the factory and needs no further lubrication. NEVER
LUBRICATE THE PNEUMATIC LIFT. Do not remove clip
from bottom of Cylinder. Contact Safco immediately if clip
is missing or damaged. Clean polyurethane seat and back
with soap and water. To repair small cuts in polyurethane,
apply a few drops of quick drying glue into the cut and press
the sides together until the glue sets.

GENERAL SAFETY INSTRUCTIONS

Do not stand on seat.
Chair must be on level surface to ensure proper stability.
Only use chair when fully assembled.
Never use chair if it does not perform according to this sheet
or warranty may be void.
Immediately report any problems to Safco and always give
the manufacturer's date code information from the label
under the seat.
ADJUST THE
SEAT ANGLE:
The seat angle adjustment
lever is the one on the right
side, under the seat. The
seat tilt is important for work
tasks that require leaning
foward. The 10 tilt allows you
o
to lean foward without extra
pressure under the thighs.
Lift the lever and shift your
weight forward until you find
a comfortable position, then
release the lever to lock into
place.
8000.02