Uline H-8783 Manual De Instrucciones página 3

OPERATING ISSUE
Rewinder feeds supply,
instead of rewinding.
Core does not stay on
core holder.
Supply is pinched when
rewinding.
Rewinder is pulling
too hard on supply or
supply perforations are
breaking.
PAGE 3 OF 9
TROUBLESHOOTING
RECOMMENDATIONS
Ensure the direction switch is set properly.
Ensure the inside core holder is the one with the small
metal clips on the edge.
Ensure the outer disk has not been pushed in too far.
Ensure the supply is fed under the pick-up arm and then
attached to the empty core or coreless adapter.
1-800-295-5510
uline.com
0621 IH-8783