Uline H-6526 Manual De Instrucciones página 2

5. Place microfiber mop head on ground with black
ring facing up. Center mop head attachment over
microfiber mop head and press down onto it. Secure
microfiber mop head by pressing down with foot on
both sides of the mop head attachment. (See Figure 5)
Figure 5
FILLING BUCKET
1. Fill bucket with a minimum two gallons of water and
add desired cleaning solution. (See Figure 6)
Figure 6
PREPARING MOP
1. Before wetting mop head in bucket, make sure
mop handle is in vertical/locked position and in "off"
position. (See Figure 7)
Figure 7
PAGE 2 OF 9
Press down
Press down
with foot with foot
Fill bucket here
OPERATION
FOOT PEDAL
1. This pedal is used to wet/clean mop head and also
ring out the mop head. To use, pump pedal down with
foot. (See Figure 8)
Figure 8
WETTING GEAR AND RINGING BUCKET
1. Use these to wet mop and to ring wet head dry.
(See Figure 9)
Figure 9
WETTING MOP HEAD
1. Place mop over gear until it locks in place. Pump
foot pedal with foot until mop is saturated. Repeat
process to clean mop head. (See Figure 10)
Figure 10
Foot
Pedal
Dry Mop Wet Mop
0721 IH-6526