Uline H-6526 Manual De Instrucciones página 3

RINGING MOP OUT
1. Place mop head in stainless steel basket and pump
foot pedal until desired dryness is achieved.
(See Figure 11) See next step for optional ringing
method.
Figure 11
RINGING MOP OUT (OPTIONAL)
1. Place mop head in stainless steel
basket. Turn mop handle to "on"
position and pump handle down
to begin spinning mop head.
Spin to desired dryness.
(See Figure 12)
Figure 12
REMOVAL AND CARING OF MICROFIBER MOP HEAD
1. To remove the microfiber mop head, pull it off with
your hands; or while the mop is in the vertical locked
position, step on the microfiber part of the mop
head (not the stainless steel mop head attachment)
that is perpendicular with the hinge movement, and
push handle away from body.
PAGE 3 OF 9
OPERATION CONTINUED
MOPPING
1.
STORAGE
1.
Pump
handle
down
2. Wash the microfiber mop head by hand with water
1-800-295-5510
uline.com
Place microfiber mop head flat on the floor and
step on either side of the mop head attachment
with foot. Push mop handle left or right to release
lock position. Mop is ready to use. (See Figure 13)
Figure 13
Foot here
Ring out the mop. Empty bucket using drain on side.
Collapse mop handle and lock it. Place mop in
holder located in bucket. (See Figure 14)
Figure 14
Drain
and soap or place in a washing machine with
detergent.
NOTE: Always allow your microfiber mop head
to air dry. Do not place in the dryer.
Mop in unlocked
position
0721 IH-6526