Uline H-4588 Manual De Instrucciones

H-4588, H-4589
H-4591, H-9495
PORTABLE SIGN BASE
TOOLS NEEDED
Phillips Screwdriver 7/16" Socket and Wrench
Bracket Pan Head
Assembly x 2 Bolt x 2
1. Attach one bolt and
one nut to each bracket
assembly. Fully tighten.
(See Figure 1)
2. Position the two bracket
assemblies onto the
PVC post in the desired
location to mount the sign.
Fully tighten the brackets
using a 7/16" wrench
and screwdriver. Slip one
washer onto each of the
two protruding bolts of the
bracket assembly.
(See Figure 2)
3. Mount the sign into place
on the two protruding bolts
of the bracket assemblies.
PAGE 1 OF 3
1-800-295-5510
uline.com
Nut x 4 Washer x 4
ASSEMBLY
Figure 1
Figure 2
Hammer
PARTS
PVC Post x 1
4. Slip one washer onto each of the two protruding
bolts over the sign.
5. Using the two remaining nuts, secure the sign to
each of the bracket assemblies.
6. Place the rubber base onto a flat surface. Wet the
bottom of the post and base hole with water to
lubricate.
7. Holding the post at a slight
angle, press fit the post into
the base. (See Figure 3)
8. Carefully pound the top
of the PVC post with a
hammer until post is snug
inside the base. Make
sure post is press fit to the
bottom of the base.
Para Español, vea página 2.
Pour le français, consulter la page 3.
Rubber Base
Figure 3
0821 IH-4588