Philips SCD510 Manual De Instrucciones página 13

Question Answer
Why don't the power-on Perhaps the rechargeable batteries of the parent unit are empty and
light of the baby unit and the parent unit is not connected to the mains. Insert the small
the LINK light of the appliance plug into the parent unit and put the adapter in a wall
parent unit come on when socket. Then press the on/off button to establish connection with
I press the on/off buttons the baby unit.
of the units?
Perhaps the non-rechargeable batteries of the baby unit are empty
and the baby unit is not connected to the mains. Replace the
non-rechargeable batteries or connect the baby unit to the mains.
Then press the on/off button to establish connection with the
parent unit.
The baby unit and the parent unit may be out of range of each
other. Move the parent unit closer to the baby unit, but not closer
than 1 metre/3 feet.
If the LINK light on the parent unit still does not start to flash, use
the reset function to reset the units to their default settings.
Why does the LINK light The baby unit and the parent unit are out of range of each other.
on the parent unit flash Move the parent unit closer to the baby unit.
red?
The baby unit may be switched off. Switch on the baby unit.
Why does the battery light The non-rechargeable batteries of the baby unit are running low.
on the baby unit flash red? Replace the non-rechargeable batteries or connect the baby unit to
the mains (see chapter 'Preparing for use').
Why does the parent unit If the parent unit beeps while the LINK light flashes red, the
beep? connection with the baby unit is lost. Move the parent unit closer to
the baby unit.
If the parent unit beeps and the battery light flashes red, the
rechargeable batteries of the parent unit are running low. Recharge
the batteries.
The baby unit may be switched off. Switch on the baby unit.
Why does the appliance The units may be too close to each other. Make sure the parent unit
produce a high-pitched and the baby unit are at least 1 metre/3 feet away from each other.
noise?
The volume of the parent unit may be set too high. Decrease the
volume of the parent unit.
Why don't I hear a sound/ The volume of the parent unit may be set too low or may be
Why can't I hear my baby switched off. Increase the volume of the parent unit.
cry?
The microphone sensitivity level of the baby unit may be set too
low. Increase the microphone sensitivity level with the SENSITIVITY
button on the parent unit.
The baby unit and the parent unit may be out of range of each
other. Reduce the distance between the units.
All manuals and user guides at all-guides.com
EngliSh
1