Helpful Tips; Troubleshooting; Cautionary Notes - TechLine MG-150f Manual Del Usuario

3. You can erase the memories stored by:
•
Remove the batteries.
•
Press and hold the memory recall key for more than 5 seconds.
4. The data in the memory zone can be erased if any of the batteries is moved away. (We suggest
the users to first record the data before replace or move away the batteries.)

Helpful Tips

Here are few helpful tips to help you obtain more accurate readings:
•
Do not measure your blood pressure immediately after consuming a large meal. To obtain more
accurate readings, please wait one hour before measuring.
•
Do not smoke or drink alcohol before measuring your blood pressure.
•
It is important that you relax during measurement. Try to take a 20-minute rest before a reading.
•
Do not take measurements if you are under stress or under tension.
•
Take your blood pressure at normal body temperature. If you are feeling cold or hot, wait a while
before taking a measurement.
•
If the monitor is stored at very low temperature (near freezing), have it placed at a warm location
for at least one hour before using it.
•
Wait about 20 minutes before taking the next pressure measurement.

Troubleshooting

If any abnormality should arise during use, please check the following points.
Symptoms
No display when the
POWER button is
pressed
EE mark shown on
display or the blood
pressure value is
displayed excessively
low (high)
Note:
If the unit still does not work, return it to your dealer. Under no circumstance should you
disassemble the unit and attempt repairs yourself.

Cautionary Notes

1. The unit contains high-precision components. Therefore, avoid extreme temperatures, humidity,
and direct sunlight. Avoid dropping or strongly shocking the main unit, and protect it from dust.
2. Clean the blood pressure monitor body and the cuff carefully with a slightly damp, soft cloth. Do
not press. Do not wash the cuff or use chemical cleaner on it. Never use thinner, alcohol or
petrol (gasoline) as cleaner.
3. Leaky batteries can damage the unit. Remove the batteries when the unit is not used for a long
time.
4. The unit should not be operated by children so to avoid hazardous situations.
5. If the unit is stored near freezing, allow it to acclimate at room temperature before use.
All manuals and user guides at all-guides.com
Check Points
Have the batteries run down?
Have the batteries' polarities been
positioned incorrectly?
Is the cuff placed correctly?
Is the cuff pressure pumped
enough? (50~60 mmHg above
normal systolic value?)
Did you talk or move during
measurement?
Did you shake the arm with the cuff on?
Correction
Replace them with two new batteries.
Re-insert the batteries in the correct
positions.
Wrap the cuff properly so that it is
positioned correctly.
Measure it again and pump up
50~60 mmHg more than normal
systolic value.
Measure it again quietly. Keep arm
steady during measurement.