TATRA TIM.2504G.A Manual Del Usuario página 26

EN
NOTE
Wait for at least 2 hours after turning on the machine to achieve the optimum ice cube size
and production time.
SHUTTING DOWN THE ICE CUBE MAKER
• Set the on/off button on the front panel of the ice maker to the OFF position.
• Power off the machine, unplug it from the socket.
• Shut off the water.
05. CLEANING AND MAINTAINING THE ICE MAKER
Make sure that the following safety instructions are observed prior to cleaning the ice maker.
1. Prior to cleaning the ice maker, turn off the power unless otherwise specified in the
cleaning instructions.
2. Never wash the outside of the machine. This may result in electrical failure and endanger
the user's life.
3. Prior to cleaning, make sure to put on protective gear such as gloves etc.
4. When cleaning, do not use sharp, cutting or other corrosive items; do not use cleaning
equipment or chemicals.
Otherwise, the machine's warranty will be void.
5. Do not use any detergents other than those recommended by Frozy.
CLEANING THE MACHINE EXTERIOR
The product body is made of stainless steel. For this reason, clean the machine with a damp
cotton cloth or sponge. Then wipe it with a dry cotton cloth.
CLEANING THE ICE CUBES TANK
1. Completely remove ice cubes from the tank.
2. Wipe the inside of the tank with a soapy cloth.
3. Wipe again with a damp clean cloth.
4. Then wipe with a dry cloth.
Avoid using descaling solutions and other detergents.
CLEANING THE DISTRIBUTION SYSTEM
Connect power and water according to the instructions.
1. The ON/OFF button shall be set to OFF, the water valve shall be open
26