Masterbuilt MWG 600B Manual De Instrucciones página 29

Troubleshooting
Figure 2
THE GRILL DOESN'T FIRE ON SMOKE SETTING
The "P" setting on the digital controller may be set too high. Review the Digital Controller Functions in the
Operating Instructions section to adjust.
FOLLOW THIS PROCEDURE TO CLEAN EXCESS ASH FROM THE CRUCIBLE.
Make sure the power switch is OFF and the power cord is disconnected.
Open the lid and remove the cooking grate, grease deflector and heat diffuser.
Remove all unburned pellets and ash from the crucible. A shop-vac will help. MAKE SURE THE GRILL IS COLD.
HOT ASH CAN CAUSE A FIRE.
Put the heat diffuser, grease deflector and cooking grate back in place and follow the INITIAL LIGHTING
INSTRUCTIONS.
Screw
Nut
Bolt
Auger Retainer
Auger Motor Shaft
Auger
29