postQuam Italian Design IDEER-6004 Manual De Instrucciones página 6

take out the battery and dispose the battery using
a method which has no harm to the environment.
INSTRUCTIONS
EN
1. Before connecting the power supply, make sure that the voltage marked on the
product matches the local supply voltage. To charge the product, insert the small plug
of the C-type charging cable into the USB port on the base, then insert the other end
of the power cable into a transformer (not included), as shown in "Fig. 1".
Note: When the transformer connector is greater than or equal to 6V, the product will
not charge.
2. Charging: When the device is charging the battery, a flashing red light on the
power switch.
3. Once charging is complete (2 hours of quick charging) the light will go out "Fig. 2".
4. Remove the protective sleeve from the cutting head "Fig. 3".
5. Press the button on the base to turn the hair clipper on (a blue light will come on) "Fig. 4".
6. Use: Move the cutting head slowly against the direction of hair growth, you can
handle with precision and ease the hair cutter in a straight line or circles.
7. To turn off the cutter press the same button as the power button "Fig. 4".
8. Always attach the desired cutting comb with the hair trimmer switched off. You can choose
the cutting height between 1 mm / 2 mm / 3 mm / 4 mm and change it as required "Fig. 5".
9. When the red indicator light flashes, it indicates that the power is insufficient and
needs to be charged on time. "Fig. 6".
Note: It is possible to continue working with the hair clipper while it is plugged in for
charging (ALWAYS NOT THE FIRST CHARGE).
Note: If the load is excessive, the device will automatically switch off (locked rotor
protection).
10. When you finish using the hair trimmer, turn it off and remove the trimming comb.
11. Replace the blade with the protective cover.
PRECISION BULLET PRECISION BULLET
6