DragonTouch Vision 3 Manual Del Usuario página 21

EN
PHOTO
To capture a photo, put the camera in Photo Mode.
To take a photo:
Press the Red Photo Button. The camera will emit a camera shutter sound.
CR2032 BATTERY REPLACEMENT FOR VISION 3 REMOTE
1. Use a 1.8 mm Phillips head screwdriver to remove the four screws on the back
cover of the remote, allowing you to open it.
2. Remove the other four screws in the PCB board.
3. Lift the PCB board and slide out the battery, as shown in the picture.
Note: Do NOT rotate the PCB board to avoid reversing the camera and video button
functions.
19