Bass Control; Treble Control - Sharp HT-SB400 Manual De Manejo

Ocultar thumbs Ver también para HT-SB400:
Tabla de contenido

Publicidad

Subwoofer level control
The subwoofer level can be adjusted.
To increase the level, press the
SUBWOOFER LEVEL
button.
To decrease the level, press the
SUBWOOFER LEVEL
button.
Note:
When sound from the speaker is distorted, decrease the
subwoofer level.
Centre speaker level control
The centre speaker level can be adjusted.
To increase the level, press the centre SPK
LEVEL
button.
To decrease the level, press the centre SPK
LEVEL
button.

Bass control

1. Press the BASS/TREBLE button
to select "BASS".
2. Within 5 seconds, press the
VOLUME (+ or –) button to adjust
the bass.

Treble control

1. Press the BASS/TREBLE button
to select "TREBLE".
2. Within 5 seconds, press the
VOLUME (+ or –) button to adjust
the treble.
All manuals and user guides at all-guides.com
During Stand-by mode, press the DIMMER/SENS ON/OFF
button on the remote control and the on/stand-by indicator will
turn from ORANGE to RED.
To turn the power on, press the ON/STAND-BY button on the
remote control or touch the ON/STAND-BY pad on the display
-5 -4 ...
+4 +5
panel.
When the FUNCTION
speaker is touched or LINE 1 - 2
button on the remote control is
pressed,
change. Touch the FUNCTION pad
on speaker or LINE button on the
remote control repeatedly to select
-5 -4 ...
+4 +5
desired input source.
Note:
The backup function will protect the memorized function mode
for a few hours should there be a power failure or the AC power
lead becomes disconnected.
-5 +5
Auto power on function:
When you press the LINE button on the remote control, the
speaker will turn on at last function.
Auto power off and auto detect signal:
The speaker will automatically off after 1 minute of inactivity.
The ON/STAND-BY indicator turns orange. At this point, it will
-5 +5
automatically power ON if it detects audio signal from connected
equipment.
Note:
Make sure to turn off any source/signal input to speaker before
going to stand-by mode because it will cause the speaker to
power ON again.
Touch Sensing Off mode
Function
pad
the
input
source
HT-SB400_A6_EN.fm
2009 October 20
on
LINE 1
will
LINE 2
HT-SB400
ENGLISH
E-14

Publicidad

Tabla de contenido
loading

Tabla de contenido