Remote Control Programming - MATTRESS FIRM 100 I/C-UBL Manual Del Propietário

Program One Remote to Operate One Base - Bases
are factory programmed to operate as one remote
control to one base. If reprogramming is required,
perform the following numbered procedure. If
programming fails, initiate the programming
procedure a second time.
STEP 1
UNPLUG the base from the electrical power source
(if plugged in) and wait 3 minutes.
STEP 2
Plug the base into the electrical power source.
You now have 3 minutes to complete the
programming procedure. The programming indicator
(under bed light) will flash to indicate programming
mode.
STEP 3
Simultaneously press and hold the head up and foot
up buttons on the remote control for 2 seconds.
Release both buttons.
Press the head up or foot up button on the remote
control to verify base functions.
One remote control is now programmed to operate
one base.

REMOTE CONTROL PROGRAMMING

Program One Remote to Operate Two Bases - Bases
are factory programmed to operate individual
bases. To program one remote to operate both
bases, perform the following numbered procedure.
If programming fails, initiate the programming
procedure a second time.
STEP 1
UNPLUG both bases from the electrical power
source (if plugged in) and wait 3 minutes.
STEP 2
Plug both bases into the electrical power source.
You now have 3 minutes to complete the
programming procedure. The programming indicator
(under bed light) will flash to indicate programming
mode.
STEP 3
Simultaneously press and hold the head up and foot
up buttons on the remote control for 2 seconds.
Release both buttons.
Press the head up or foot up button on the remote
control to verify base functions.
One remote control is now programmed to operate
two bases.
Note: The second remote is not needed. Store it for
use as a spare.
BASE 1
BASE 2
100 I/C-UBL Adjustable Base Owners Manual 290-0029-d
9