NEC MultiSync FE2111SB Manual Del Usuario página 2

DOC: This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
C-UL: Bears the C-UL Mark and is in compliance with Canadian Safety Regulations according to CSA C22.2 #950.
FCC Information
1. Use the attached specified cables with the MultiSync FE2111
reception.
(1) Please use the supplied power cable or equivalent to ensure FCC compliance.
(2) Shielded video type signal cable.
Use of other cables and adapters may cause interference with radio and television reception.
2. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult your dealer or an experienced radio/TV technician for help.
If necessary, the user should contact the dealer or an experienced radio/television technician for additional suggestions. The user
may find the following booklet, prepared by the Federal Communications Commission, helpful: "How to Identify and Resolve Radio-
TV Interference Problems." This booklet is available from the U.S. Government Printing Office, Washington, D.C., 20402, Stock No.
004-000-00345-4.
No user serviceable parts inside. Do not attempt to modify this equipment. If modified, your authority to operate this equipment might
be voided by FCC.
® is a U.S. registered trademark. All other brands and product names are trademarks or registered trademarks of
E S
NERGY TAR
their respective owners.
As an E Partner, NEC-Mitsubishi Electric Visual Systems Corporation has determined that this product meets the
S
NERGY TAR
E S guidelines for energy efficiency.
NERGY TAR
The E S emblem does not represent EPA endorsement of any product or service.
NERGY TAR
All other trademarks mentioned in this manual are the property of their respective owners.
01_cover.p65 2
All manuals and user guides at all-guides.com
Canadian Department of Communications Compliance Statement
SB colour monitor so as not to interfere with radio and television
14/5/02, 11:55 am