Electric Safety - Toparc NUM MIG-1 Manual Del Usuario

WARNINGS - SAFETY RULES
GENERAL INSTRUCTION
These instructions must be read and understood before any operation.
Any modification or maintenance not indicated in the manual must not be undertaken.
The manufacturer shall not be held liable for any personal injury or material damage caused by use not in accordance with the instructions in this
manual. In the event of a problem or uncertainty, consult a qualified person to handle the installation correctly.
This manual describes the wiring of this product. Any user who does not strictly comply with the safety instructions described in this manual may
be exposed to electrical risks and/or a serious or even fatal accident.

ELECTRIC SAFETY

During any intervention on the product, make sure to secure the area by keeping at a distance any person who has not read the instructions of safety
described in this manual. This product should preferably be installed by a professional in accordance with the installation rules in force in the country.
If not, it is recommended that you read these rules before working on it.
PRECAUTIONS AGAINST ELECTROSTATIC DAMAGE
Static electricity can damage electronic equipment. Use a grounded anti-static wrist strap, an ankle strap, or equivalent safety device
to prevent electrostatic damage (ESD) when installing this product.
Electrostatic damage can irreparably damage the generator and/or the product. To protect electronic components from electrostatic damage, place
this product on an antistatic surface, such as an antistatic discharge mat, antistatic bag, or disposable antistatic mat.
KIT CONTENTS
Electronic card
97802C
300 mm
Wire harness
Case connector cover
550 mm
PRESENTATION
The digital Kit NUM MIG-1 (ref. 062993) allows an additional application on compatible MIG/MAG generators. It allows you to add an automation
module (SAM) or to combine several options.
Compatibility
NEOPULSE 320 C
PULSEMIG 320 C
NEOPULSE 400 CW
PULSEMIG 400 CW
NEOPULSE 400 G
PULSEMIG 400 G
NEOPULSE 500 G
PULSEMIG 500 G
Kits needed
KIT NUM MIG-1
Wire harness
550 mm 300 mm
Support card
SAM
ref.
(064935)
062474
062641
062061
062658
014497
062665
014503
062672
NUM MIG-1
(062993)
RJ45 Cable
Cable DB9
750 mm
500 mm
300 mm
(x2)
Some configurations do not require all the elements of the Kit.
Remote
SAM
+
control
(064935)
(062122)
NUM MIG-1
(062993)
NUM-1
(063938)
EN
Adapter
Support plates
Sub-D9
Double wire feeder
+ Remote control
(062122)
2x NEOFEED-4W 2x PULSFEED-4W
(014527) (062689)
- -
- -
- -
- -
-
-
-
-
NUM MIG-1
(062993)
NUM-1
(063938)
NUM-2
(064942)
5