Initial Setup - Oasis 504815C Guia Del Usuario

INSTALLATION
1. After unpacking, wipe cooler with soft cloth.
2. Place the machine on a hard, flat surface, making certain the unit is level. The unit should not be placed near direct
sunlight or any other source of heat.
3. It is best to place the water cooler in an area with good air circulation. Make sure there are at least 4 inches (10 cm)
of space between the back of your water cooler and the wall. Keep a minimum distance of 2 inches (5 cm) on each
side of your water cooler.
WARNING: The drain plug on the back of the unit may loosen during shipping. Securely tighten the drain plug before
starting the unit. A loose drain plug may leak, causing floor damage.
PREPARING THE WATER COOLER FOR USE
This model is different from a traditional water cooler with the water bottle upside down on
the top of the unit. Instead, the water bottle is placed upright in the lower cabinet with a pump
drawing the water up to the dispenser.
IMPORTANT:
• Much like a new refrigerator with an ice maker or water dispenser, it is recommended to run
1 or 2 gallons of water through the system before use.
• Always wash your hands first before handling the water bottle and stainless-steel siphon tube.
Clean the top of the bottle with a clean cloth.
• A water bottle can be purchased from your local retailer.
INITIAL SET-UP
1. Make sure the water dispenser is not plugged into an electrical outlet.
2. Open the lower cabinet door.
3. Place full water bottle on floor. Remove the plastic cap from the mouth of the water bottle.
4. Place the stainless-steel siphon tube inside the bottle and place the water bottle cap firmly over the mouth
of the water bottle.
5. Slide the siphon tube down until it reaches the bottom of the bottle. See page 5, "ADJUSTING THE SIPHON TUBE
FOR SMALLER BOTTLES".
6. Slide the bottle inside the cabinet and close the lower cabinet door.
7. Plug the water cooler into a grounded GFCI power outlet, and turn on the green
power switch located on the back, near the top.
8. The unit will start to operate, but wait at least an hour to use it, allowing the water to
reach the proper temperature.
9. This unit is equipped with a switch that turns the hot tank ON and OFF. Make sure
water can be dispensed from the hot faucet before switching the hot tank switch
to ON. If you are not going to use hot water, turn the hot tank switch to OFF to
conserve energy.
10. Read "SETTING UP YOUR OZONATION CYCLE" on page 6 and follow instructions.
NOTE: If there is not a secure connection between the hose cap and the connector on
the water cooler, the water pump will operate but the water cooler will not dispense water. Make sure the hose is
connected to the water cooler correctly. See page 7, "WATER TUBE CONNECTION/DISCONNECTION PROCEDURES".
NOTE: Please wait until the water pump stops running before using the unit. If the water tank is not full, no water will
dispense from the hot and cold water faucets.
4
oasiscoolers.com