Installation Steps; Care And Cleaning - AVS Ventvisor Deflector Instrucciones De Instalación

Installation Steps

Align the visor to the vehicle by positioning rear end
flange on the vertical post. Then align the lateral flange
on the painted surface just above the trim, and the front
end flange onto the door trim.
3
With the visor in its final position, remove remaining
tape liner by pulling on free ends.
5

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International,
Inc. We take the utmost pride in our products and want you to enjoy years of satisfaction from your investment.
We have made every effort to ensure that your product is top quality in terms of fit, durability, finish and ease of
installation.
™ Auto Ventshade
NOTE: Actual application may vary slightly from illustrations.
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2005 Lund International, Inc. All rights reserved.
, the Auto Ventshade logo and the AVS
TM TM
Press gently along exposed tape area to secure in po-
sition. Open door to verify that visor does not interfere
4
Apply pressure along tape flange to secure.
6
Repeat steps 1 through 6 for
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2
with door operation.
passenger side visor.