Ryobi BID1821 Manual De Utilización página 5

GB
FR DE ES
SPECIFICATIONS
MODEL BATTERY PACK
(not included)
BPL-1820
BID1821
BPL-1815
BPP-1815
BPP-1815M
BPP-1817
BPP-1817M
OPERATION
WARNING
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING
Always wear safety goggles or safety glasses with
side shields when operating products. Failure to do
so could result in objects being thrown into your
eyes, resulting in possible serious injury.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
„
Fastening/removing screws and bolts.
This product will accept Ryobi One+ 18 V lithium-ion
battery packs and Ryobi One+ 18 V nickel-cadmium
battery packs.
WARNING
Always remove battery pack from your impact
driver when you are assembling parts, making
adjustments, assembling or removing bits,
cleaning, or when not in use. Removing battery
pack will prevent accidental starting that could
cause serious personal injury.
IT NL PT DK SE
CHARGER
(not included)
BCL-1800
BCS618
BCL1418
BCL14181H
BCL14183H
BCA-180
BC-1815S
BC-1800
BCL-1800
BCS618
BCL1418
BCL14181H
BCL14183H
FI NO RU PL CZ
English
BATTERY PROTECTION FEATURES
Ryobi 18 V lithium-ion batteries are designed with
features that protect the lithium-ion cells and maximize
battery life. Under some operating conditions, these
built-in features may cause the battery and the tool it is
powering to act differ-ently from nickel-cadmium batteries.
During some applications, the battery electronics may
signal the battery to shut down, and cause the tool to
stop running. To reset the battery and tool, release the
trigger and resume normal operation.
NOTE: To prevent further shut down of the battery, avoid
forcing the tool.
If releasing the trigger does not reset the battery and
tool, the battery pack is depleted. If depleted, the battery
pack will begin charging when placed on the lithium-ion
charger.
TO INSTALL BATTERY PACK
See Figure 2.
„
Place the direction of rotation selector in the center
position.
„
Insert the battery pack into the product as shown.
„
Make sure the latches on each side of the battery
pack snap in place and that battery pack is secured in
the product before beginning operation.
TO REMOVE BATTERY PACK
„
Depress the latches on each side of the battery pack.
„
Remove the battery pack from the drill.
WARNING
Batter y products are always in operating
condition. Therefore, the switch should always be
locked when not in use or carrying at your side.
CAUTION
The metal surface may become hot during use.
Avoid contact with it to avoid possible burn injury.
SWITCH TRIGGER
See Figure 3.
To turn the drill ON, depress the switch trigger. To turn it
OFF, release the switch trigger.
VARIABLE SPEED
The variable speed switch trigger delivers higher speed
with increased trigger pressure and lower speed with
decreased trigger pressure.
2
HU RO LV LT EE HR SI SK GR TR