KTM Power Parts 50303190100 Manual De Instrucciones página 4

1
4
2
Scope of supply
1x GPS bracket Streetpilot 26xx/27xx/28xx
Install the handlebar mount on the crossbar or on a suitable adaptor. To get
your GPS in the bracket, you'll have to tilt the ajustable mount (1) at the back
completely backwards
Then open the locking lever (2), by pulling it on the back and pushing it in
the front. Now you can move the device into the bracket so that the round
disk at the bottom fits into the clearance.
2
Close the locking lever (2) so that it noticeable snaps in. Lock the bracket
and connect the electric cable. On the right side of the bracket you can find
a special mount (3) for your power cable (for rides without the device). To
remove the power cable from that holder please lift it slightly on the right
side. At the back of the device you'll find a plastic pen to handle the touchs-
3 creen with gloves. Always take a look that your GPS unit is attached secu-
rely to your bracket. KTM does not take any responsibility for damaged or
lost GPS units.
60112092010