Troy-Bilt Zero-Turn Manual De Instrucciones página 11

Adjusting the Seat
1. To adjust the position of the seat, push the seat adjustment
lever to the left. See Figure 4-6.
2
Figure 4-6
2. Slide the seat forward or rearward to the desired position;
then release the adjustment lever. Make sure seat is locked
into position before operating the tractor. See Figure 4-6.
Transmission Oil Expansion Reservoir
The transmission oil expansion reservoir is connected by hoses
to the RH and LH transmission assemblies, and is located behind
the seat box. The function of the reservoir is to hold the natural
expansion of transmission oil that occurs as the transmission
warms up during operation. DO NOT FILL THE RESERVOIR.
Under normal operating conditions, no oil should be added
to the reservoir. The COLD oil level should be no higher than
approximately 1⁄4" (the "Full Cold" mark) above the bottom of
the reservoir. See Figure 4-7.
1
NOTE: Prior to the initial operation of the tractor, the
oil level in the reservoir may be slightly higher than the
maximum due to air in the oil lines. Operation of the tractor
will eventually purge the air from the lines and the oil level
will settle to the maximum.
Figure 4-7
S 3 — A & S
ection SSembly et
-U 11
p