Fuel Valve - Troy-Bilt Zero-Turn Manual De Instrucciones

Fuel Valve

The fuel valve is located on the inner side of
the RH console. The valve switches the fuel
flow from the right and left tank and also
can shut off fuel flow to the engine. Rotate
the valve to the rear to open the flow from
the right fuel tank . Rotate the valve to
the front to open the flow from the left tank
. To shut off fuel from both tanks rotate
the valve towards the right of the tractor
and the OFF position. See the Operation
section for more information on using the
fuel valve.
Transmission Oil Expansion Reservoir
The transmission oil expansion reservoir is connected by hoses
to the RH and LH transmission assemblies, and is located behind
the seat box. The function of the reservoir is to hold the natural
expansion of transmission oil that occurs as the transmission warms
up during operation. See the Maintenance & Adjustments section
for more information on the transmission oil expansion reservoir.
LCD Service Minder & Hour Meter
When the ignition key is rotated out of the STOP position but not
into the START position, the LCD Service Minder and Hour Meter
will briefly display the battery voltage, followed by the tractor's
accumulated hours.
NOTE: Hours of tractor operation are recorded any time the
ignition key is rotated out of the STOP position, regardless of
whether the engine is started.
The LCD Service Minder will remind the operator of maintenance
intervals for changing the engine oil, air filter service, low engine
and low battery warnings.
Change Oil
The LCD will display the letters "CHG", followed by the letters
"OIL", followed by the letters "SOON", then finally followed by the
meter's accumulated time. "CHG/OIL/SOON/TIME" will alternate
on the display for 7 minutes after the meter reaches 50 hours.
This oil service minder interval will occur every 50 hours. Before
the interval expires, change the engine oil as instructed in the
Maintenance section of this Operator's Manual.
Low Oil Pressure
NOTE: The low oil pressure function only works if the engine is
equipped with an oil pressure switch.
The letters "LO" followed by the letters "OIL", then followed by
the meter's accumulated time will indicate the engine has low oil
pressure. This is common when starting an engine. The indicator
will remain active until the engine sufficiently builds pressure
after starting. If it remains on with the engine at full speed and
after a few minutes of operation, stop the tractor immediately
and check the engine oil level as instructed in this Operator's
Manual. If the oil is low, add as instructed in the Engine
Operator's Manual. If the oil level is correct and the indicator
persists, contact an authorized service dealer.
Low Battery
At startup, the battery voltage is briefly
displayed then changes to accumulated
hours. The letters "LO" will display
followed by the letters "BATT" and then followed by the meter's
accumulated time. "LO/BATT/TIME" is displayed on the LCD when
the voltage drops below 11.5 volts. When this occurs, the battery
is in need of a charge or the engine's charging system is not
generating sufficient amperage. Charge the battery as instructed
in the Service section of this manual or have the charging system
checked by your local service dealer.
Air Filter Service
The letters "CLN" will display, followed by
the letters "AIR", followed by "FILT", then
followed by the meter's accumulated time.
"CLN/AIR/FILT/TIME" will alternate on the
display for 7 minutes after the meter reaches 25 hours. This air
filter service minder time interval will be every 25 hours. On
intervals that are common with oil service, the oil message will
be displayed first followed by the air filter message.
S
ection
4 — c & F
ontrolS eatureS
15