Acuity Brands JUNO FLEX 12 Instrucciones De Instalación

FLEX 12 LOW VOLTAGE TRAC LIGHTING SYSTEM
WARNING: MAKE SURE POWER IS OFF BEFORE INSTALLATION OR REMOVAL OF
TRAC FIXTURES OR RELAMPING.
INSTRUCTIONS PERTAINING TO A RISK OF FIRE OR INJURY
IMPORTANT SAFETY INSTRUCTIONS
1. Lighted LED is HOT!
2. LED gets HOT quickly.
3. Do not install any fixture closer than 6" (15.25cm) from any curtain or similar
combustible materials.
4. For fixtures designed to be used with a lens, do not operate fixture if lens is
damaged or missing.
5. Fixtures to be used only with Juno 12V TF Series Trac. Use with non-Juno trac may create
a safety hazard and voids the Juno warranty and the UL and CSA listings.
6. For use with 12V power unit.
SAVE THESE INSTRUCTIONS
Remove adapter cap.
1. Slide adapter straight up into trac.
2. Replace and tighten cap.
3. Do not slide adapter along the trac.
To relocate fixture along trac:
Remove adapter cap, slide adapter straight
down off trac, relocate repeating steps
1 & 2 above. Adjust fixture aiming angle(s)
as needed. DO NOT FORCE.
CAUTION: The optical lens in this fixture
can be removed and replaced with a different
optical lens accessory to change beam spread.
DO NOT REMOVE OR RE-INSTALL THE
OPTICAL LENS WHEN FIXTURE IS HOT.
Always allow the fixture to cool before removing
or installing the optical lens. The LED is fragile
and may be damaged if these instructions
are not followed. Juno Lighting Group is not
responsible for damage caused by removing or
installing the optical lens in a hot fixture.
1300 S. Wolf Road • Des Plaines, IL 60018 • Phone 800-323-5068
Visit us at www.acuitybrands.com/juno-trac
©2017 Acuity Brands Lighting, Inc.
INSTALLATION INSTRUCTIONS
FOR JUNO FLEX 12 TRAC FIXTURES
Rev 3/17 P3446
1 of 2