HPS Centurion P Guía De Instalación, Operación Y Mantenimiento página 11

Removable front
access panel
Optional bottom entry
Position fork lift
under pallet
Recommended cable
entry location (both
sides). Refer to outline
drawing for exact
dimensions.
Removable front
access panel
Optional bottom entry
Position fork lift
under pallet
Suggested Cable Entry Locations
Cable entrance knockouts
(2 per side)
For final positioning with pallet
removed, fork lift points are under
the passive filter. Forks must be
inserted all the way through the
depth.
For final positioning with pallet
removed, fork lift points are under
the passive filter. Forks must be
inserted all the way through the
depth.
APPENDIX C
FIGURE 1
Typical Type 3R, DH1 to DH4 Ventilated Enclosure
Assembly for Passive Harmonic Filters.
Notes:
1. Handling - units are designed to be raised by a fork lift
from underneath the pallet. Final positioning of the unit
with the pallet removed can be via a fork lift under the
passive harmonic filter with the forks between the
channels.
2. Shipping - units are shipped on pallets which are to be
removed at installation.
3. Installation - This passive harmonic filter can be installed
indoor or outdoor providing a degree of protection
against falling rain, sleet and external ice formation.
4. All passive harmonic filters should be located away from
any wall or any other obstruction, please refer to the
nameplate for the minimum distance.
5. DO NOT block bottom ventilation area
FIGURE 2
Typical Type 3R, DH5 to DH10 Series Ventilated Enclosure
Assembly for Passive Harmonic Filters.
Notes:
1. Handling - units are designed to be raised by a fork lift
from underneath the pallet. Final positioning of the unit
with the pallet removed can be via a fork lift under the
passive harmonic filter with the forks between the
channels. (Note: Passive harmonic filters weighing
greater than 2350 lbs should be lifted by removing
the top panel and accessing the lifting provisions on
top of the top of the core and coil.)
2. Shipping - units are shipped on pallets which are to be
removed at installation.
3. Installation - This passive harmonic filter can be installed
indoor or outdoor providing a degree of protection
against falling rain, sleet and external ice formation.
4. All passive harmonic filters should be located away from
any wall or any other obstruction, please refer to the
nameplate for the minimum distance. (Note: These
enclosures are not intended to be wall mounted. They
may be mounted on a customer supplied platform.)
5. DO NOT block bottom ventilation area.
11
IOMGPF / June 2021