SDMO PHOENIX 2800 Manual De Utilización Y Mantenimiento página 16

3.5. Starting the generating set
Before use:
- find out how to stop the generating set in an emergency,
- ensure you fully understand all the controls and manoeuvres.
IMPORTANT
To stop the generating set in an emergency, switch the control or the on/off key to "OFF" or "O".

Check that the generating set is correctly earthed (see § Earthing the generating set).

Open the fuel tap (A - 6).

Place the choke tab (A - 8) in position "II".
N.B: Do not use the choke when the engine is warm or when the atmospheric temperature is high.

Set the on/off control (A - 9) to "

Slowly pull the starter-recoil reel handle (A - 10) until there is some resistance then let it return gently.

Then pull the starter-recoil reel handle quickly and sharply until the engine starts.

Slowly set the choke tab to position "I" position and wait until the engine temperature starts to increase before using the generating
set.
If the engine has not started, repeat the procedure until the engine starts while gradually opening the choke.
3.6. Using the electricity supplied
When the generating set speed has stabilised (approximately 3 minutes):

Check that the circuit breakers (A - 11) are depressed. Push in if necessary.

Connect the equipment to be used to the electrical sockets (A - 12) on the generating set.
3.7. Switching the generating set off
Always ensure that the generating set is suitably ventilated: the motor continues to give out heat after the
generating set has been shut down.
Make sure the fuel tap is closed.
IMPORTANT

Disconnect the electrical connectors (A - 12) and allow the engine to run without any load for 1 to 2 minutes.

Set the on/off control (A - 9) to "OFF" or "O ": the generating set stops.

Close the fuel tap (A - 6).
O N " or " I " .
O N " I "