Uline H-878 Instrucciones De Instalación página 2

NOTE: Screws are not included with dispenser.
1. Hold dispenser up to desired location and mark two
holes on the wall where screws will be inserted.
(See Figure 2)
Figure 2
1. Remove perforated tab from toilet seat cover pack.
PAGE 2 OF 6
MOUNTING INSTRUCTIONS − SCREWS
Screw Locations
LOADING INSTRUCTIONS
Figure 4
2. Drill into wall at two marked locations with
appropriate-sized drill bit. Insert wall anchors if
necessary. (See Figure 3)
Figure 3
3. Hold dispenser over previously drilled holes and
insert screws.
2. Insert pack from bottom of dispenser. Push the
bottom of the pack towards the front of dispenser to
keep it in place. (See Figure 4)
1-800-295-5510
uline.com
0621 IH-878