Uline H-1130 Guia De Instalacion

H-1130, H-3476
BULK SOAP DISPENSERS
OPENING THE DISPENSER
1. To open the dispenser lid, insert key into slot at back,
right side of lid and push in on key. (See Figure 1)
2. Back lid will pop off. (See Figure 2)
Figure 1
GENERAL MOUNTING INSTRUCTIONS
• Use the included tape on glazed tile, painted metal
or unpainted metal walls. Tape will not perform
satisfactorily if wall surface is porous like brick or
wood.
• On all other wall surfaces, use screws and anchors
(not included) or other appropriate hardware based
on surface type.
• Locate dispenser above a sink or counter.
Recommend never locating where spillage can fall
on floor creating hazardous conditions.
• Installer will be held responsible for proper
installation.
• To be in compliance with ADA regulations, the
dispenser should be mounted no more than 48"
from the ground.
PAGE 1 OF 6
1-800-295-5510
uline.com
INSTALLATION
MOUNTING WITH DOUBLE-SIDED TAPE
1. Thoroughly clean wall surface and let dry
2. Peel off paper from back of tape (supplied). Press
3. Wait 24 hours before filling with soap to ensure that
MOUNTING WITH SCREWS
AND ANCHORS (NOT INCLUDED)
1.
Figure 2
2. Using the back plate as a template, mark hole
3. Drill 3/16" diameter holes for anchors and screws or
Pour le français, consulter les pages 5-6.
completely. For silicone build-up, use a pumice-
type cleaner or grout cleaner to clean the surface.
dispenser firmly to the wall and hold for at least 30
seconds to make sure tape has completely adhered
to the wall. (See Figure 3)
the tape has completely adhered to the wall before
adding weight.
Remove lid (as described previously). Push latch out
and detach dispenser from back plate.
(See Figure 4)
locations on wall.
other hardware. Attach dispenser to back plate and
replace lid.
Figure 3
Para Español, vea páginas 3-4.
Figure 4
0521 IH-1130