Rimax Baby CYBER MAX RB212 Manual De Usuario página 19

User manual
Wireless Receiver Installation
Determine if you will be using the Receiver Cradle, or connecting the cables directly to the receiver
before installation:
1. Place the Receiver Cradle or Receiver in a place that will have clear reception with your camera(s).
2. Plug the AC adaptor power output cable into the 5V POWER input of the Cradle or Receiver. Plug the
power plug into a wall outlet or surge protector.
3. Leave the receiver to charge for 6 hours prior to fi rst time use so the built-in rechargeable receiver
battery is fully charged. DO NOT remove the power cable from the receiver / from the cradle during
initial charging process. After initial charge, charge as required.
4. If you wish to view the Receiver images on a larger screen, connect the included AV Cable to the
Cradle or Receiver, and connect the other end of the Cable to the Video IN (Yellow) and Audio IN
(White) ports on the TV, VCR or other viewing/recording device.
NOTE: the purpose of the AV output is for convenience only. When using with large screen TV/
Monitor, the picture might be grainy as the camera limits video resolution to QVGA (320x240
pixels). This is not a product defect. For best performance use with TV/Monitor PIP (Picture in
Picture) function.
Check your TV/Monitor product manual to see if this feature is available on your TV/Monitor. This
allows you to view TV or other video source and see video from the camera in a small window on the
same screen.
Camera
1. Camera Antenna – Receives & Sends signals to or from the Receiver.
2. Lens / Cover LED IR - Infrared LEDs provide viewing in
no/low light conditions.
3. Microphone - Receives sounds for the area near the
camera, and transmits sound from the Camera to the
Receiver.
4. Light sensor - Detects the light level in the room
and connect the infrared night vision automatically and
connects the nightlight.
5. Speaker: Relays the sound emitted from the monitor.
6. ON / OFF: Turns the Camera ON or OFF.
7. PAIR button (Pair) - The pairing button is located on
the back of the camera, behind the supporting table.
8. 5V DC Power - Connect the DC 5V Power Adaptor to
the Camera.
9. Temperature sensor
10. Night Light
NOTE: The Camera can also be powered using 4 AA
Batteries (not included) installed in the base. If the Camera
is plugged in with the AC Adaptor, the batteries will not be
used. The batteries are intended for short term, portable
Camera use.
EN
9
5
8
19
Cyber Max RB212
10
6
7