Rimax Baby CYBER MAX RB212 Manual De Usuario página 20

User manual
Camera Installation
Before you install the camera, carefully plan where and how it will be positioned, and where you will route
the cable that connects the camera to the power adaptor.
Before starting permanent installation, verify its performance by observing the image on the receiver when
camera is positioned in the same location/position where it will be permanently installed and the receiver is
placed in the location where it will be used most of the time.
Installation Warnings:
Aim the Camera(s) to best optimize the viewing area: Select a location for the camera that provides a clear
view of the area you want to monitor, which is free from dust, and is not in line-of-sight to a strong light
source or direct sunlight.
Avoid installing the cameras where there are thick walls, or obstructions between the Cameras and the
Receiver.
Night Vision
This camera has built-in IR LEDs, which provides the camera with the ability to view images in no/low
light conditions. It is important to use the provided power adaptor (and not the Batteries) when using the
camera for prolonged periods in low light conditions, as the built-in IR LEDs will drain the battery more
quickly than regular daytime use.
Installing the Camera:
1. Carefully unpack the Camera.
2. Mount the camera to the wall:
Mark the position of the screw holes on the wall. Drill
holes and insert 2 screws.
Firmly attach the camera to the wall by placing the
stand over the installed screws and pushing the base
downwards to secure.
NOTE:
The camera can also be placed on a fl at surface, such as a
Table or Shelf, and no mounting hardware is required.
3. Adjust the Viewing angle of the Camera.
NOTE:
You can install additional cameras (maximum of 4
cameras). When adding cameras that were not included
in the original box; you will need to pair up the cameras
with the receiver. Refer to the camera pairing section of
this manual.
Connecting Camera Power
The Camera can be powered either by using the provided Power Adaptor, or using Batteries (requires 4 x
'AA' type batteries, not included).
EN
Position the Base holes over the screws.
Slide the base down to lock the base in
place.
20
Cyber Max RB212