Factory Default; System Settings; Conax - Salora DVB 420-T Instrucciones De Manejo

34
Receiver Upgrade
On this menu you can upgrade the receiver software. The upgrading can
be made on different ways; directly from a connected computer or over
the air from the antenna. Follow the instructions viewed on the screen.
Note! Current button functions are shown on the lower part of the
screen.

Factory Default

With this function you can reset the receiver to factory preset state. After
resetting the receiver must be set up again, e.g. tuning channels. Follow
the instructions viewed on the screen.

System Settings

On this menu you can do following settings:
TV Select signal type through Scart connector
RF Channel RF channel out
RF Mode RF channels colour/sound norm
Screen Type picture format
Menu Transparency
Menu Language desired OSD language
Audio Language desired audio language
OSD Color the colour of the menus
Note! Current button functions are shown on the lower part of the
screen.

Conax

To receive scrambled programmes you need a Smart card from the
service provider.
The card reader is situated behind a flap on the receiver front panel. The
flap is opened by tilting it down. Insert the Smart card with the gold chip
edge first and the chip faced downward.
With this function you can check the features of the Smart Card.
Main menu
Flap
83040161Gb