Sangean DPR-16 Instrucciones De Manejo página 28

Presetting stations in DAB and FM modes
There are 5 memory presets each for DAB and FM radio. They are
used in the same way for each operating mode.
. Press the Standby button to switch on your radio.
2. Tune to the required radio station as previously described.
3. To store the station as a preset, press and hold the required
Preset button (1 – 5) until the display shows 'Preset stored'. The
station will be stored under the chosen preset button. Repeat this
procedure as needed for the remaining presets.
4. Stations which are already stored in the presets may be over
written by following the above procedure.
Note:
The radio station presets are retained in memory when the radio is
switched off and disconnected from the mains supply.
Recalling a preset in DAB and FM modes
. Press the Standby button to switch on your radio.
2. Select the required operating mode using the Mode button.
3. Momentarily press the required Preset button. Your radio will
then tune to the station stored in the selected preset memory.
The chosen preset number is also shown in the lower area of the
radio display, e.g. 'P2'.
27
All manuals and user guides at all-guides.com