BelFox Drive Portal Instrucciones De Montaje página 75

1 1 9 9 . . P P o o r r t t s s ( ( c c o o n n t t r r o o l l u u n n i i t t 4 4 7 7 - - 2 2 1 1 - - 0 0 o o r r o o p p t t i i o o n n a a l l 4 4 7 7 - - 2 2 1 1 - - i i ) )
Fatal electric shock from mains voltage!
There is a risk of life-threatening / fatal electric shock on contact with the mains
voltage.
SAFETY INSTRUCTIONS FOR HAZARD AVOIDANCE
• Electrical connections may only be carried out by a qualified electrician.
• Installation, adjustment and maintenance may only be carried out by
qualified personnel!
• Switch off the voltage before carrying out work on the actuator!
• Reliable operation is only ensured if the drive is carefully installed in
accordance with these instructions!
• Do not switch off the voltage until you have carefully checked it again.
Note the polarity
•
Never apply 230V to terminals 7 or 8! This will immediately destroy the
control unit and void the warranty!
Damage to the controller due to moisture / dirt
Penetrating moisture, dust or dirt can permanently damage or destroy the
controller.
SAFETY INSTRUCTIONS FOR HAZARD AVOIDANCE
Protect the controller from moisture, dirt and direct sunlight when opening the
controller housing.
(Attention: Changes may occur here. Please observe the enclosed instructions
for the control unit)
You will find the cable diagrams for the 47-21-11AW and 47-21-i on pages 44
and 45 of this manual
All safety devices:
- the receiver of the one-way photocell
- the receiver of the radio transmission system
- all four secondary closing edges
DANGER
NOTE
27