General Information - Ex-Cell ES4 Manual De Instrucciones

All manuals and user guides at all-guides.com
pressure by depressing trigger, and disconnect power source. NEVER
assume system pressure is zero!
DO NOT EXCEED PRESSURE LIMIT OF AIR BRUSH!
connections for a weak or worn condition that could render system
unsafe. All replacement components such as hose or fittings must have
a working pressure equal to or greater than system pressure.
This air brush is ideal for brushing t-shirts, models, auto designs, and general
craft applications.
1. Attach hose to air supply.
To attach to air compressor use the adapter.
To attach to C0
2. Attach hose air to brush body.
3. Air should be regulated between 15-50 PSI. Normal operating pressure is 20
psi.
Hose
Aerosol Propellant
Can Adapter
D28273

GENERAL INFORMATION

Before disassembly or removal of any part of air brush
or attached components, shut off compressor, release
TO AVOID CREATING AN EXPLOSIVE ATMOSPHERE,
WORK ONLY IN WELL-VENTILATED AREAS.
USE OF A FACE MASK IS RECOMMENDED TO PRE-
VENT INHALATION OF TOXIC MATERIAL.
OPERATION
Pressure may vary according to viscosity of material
used. Maximum working pressure of air brush is 50 psi.
Prior to daily operation, make certain that all
connections and fittings are secure. Check hose and all
2 Tank use the aerosol propellant can adapter.
Stem
Wrench
Trigger
DO NOT exceed 50 psi.
4- ENG
Extra Jar
Adapter
Air
Brush
Body
Regulator Tip