Ex-Cell ES4 Manual De Instrucciones página 5

All manuals and user guides at all-guides.com
IMPORTANT: The use of a pressure gauge and air filter is recommended.
4. Insert stem of jar into hole at bottom of air brush body. Twist and push the
stem firmly in place.
5. Depress spray gun trigger fully to spray material.
Spraying Tips
1. Use less air pressure when working close.
2. Working close to a surface produces a fine spray, increasing the distance
will widen the spray.
3. To adjust the paint sprayed turn the regulator down for less paint and up for
more paint.
source of heat or sparks. Properly dispose of used cleaning materials.
possibly make motion uneven. NEVER use lye or caustic alkaline solu-
tion for cleaning. Such solutions will attack aluminum alloy parts of air
brush.
It is important the air brush be cleaned daily or after each use.
Cleaning
NOTE: Clean air brush immediately after use. Paint and other materials dry
quickly in the small passages.
1. Turn off air supply to air brush.
2. Remove jar and air hose from air brush
body .
3. Using the wrench, loosen the brass
stem and lock nut . Remove regulator
assembly (brass stem, lock nut, and tip).
4. Soak brass stem, lock nut, and tip in a
solvent until all paint is removed.
NOTE: Always comply with local codes
when disposing of solvents.
5. To replace, insert regulator tip into hole
under nozzle. Holding the regulator tip
and lock nut in place, insert regulator
stem fully into air brush body and
tighten lock nut. NOTE: Tighten lock nut
by hand and secure by tightening brass stem with wrench.
NEVER point air brush at self or any other person. Acci-
dental discharge of material may result in serious injury.
MAINTENANCE
Always exercise extreme care when using any solvent
or thinner. Never clean air brush near fire, flame, or any
DO NOT soak entire air brush in solvent or thinner for a
long period of time as this will destroy lubricants and
5- ENG
Tip
Lock
Nut
Brass
Stem
D28273