Rockwell Automation Allen-Bradley SLC 5/01 Instrucciones De Instalación página 7

All manuals and user guides at all-guides.com
1. Open the door of the processor.
2. Remove the jumper from the battery connector socket. Store the jumper in a
safe place for possible future use without the battery.
3. Insert a new or replacement battery in the holder making sure it is held in by
the retainer clips.
4. Plug the battery connector into the socket. See the figure below.
White
Lead
Red
Lead
5. Close the processor door.
IMPORTANT
Install the Processor
Make sure system power is off; then insert the processor into slot 0 of the 1746
chassis.
IMPORTANT
Battery
Connector
Retainer
Clips
See page 11 for information on proper battery handling,
storage, and transporting.
The SLC 500 Modular Processors must be inserted into the left
slot (slot 0), as shown below. In addition, remove the
protective wrap after installing the processor.
SLC 5/01™ and SLC 5/02™ Modular Processors
+
Publication 1747-IN011B-MU-P - July 2002
7