Apply Power To The Processor - Rockwell Automation Allen-Bradley SLC 5/01 Instrucciones De Instalación

All manuals and user guides at all-guides.com
8 SLC 5/01™ and SLC 5/02™ Modular Processors

Apply Power to the Processor

1. Energize the chassis power supply.
2. Check the chassis power supply and processor LEDs. The power LED on
the power supply should be on and the fault LED on the processor should
be flashing.
Load Your Software
Refer to your programming software documentation.
Publication 1747-IN011B-MU-P - July 2002
Power
Supply
Card Guide
Protective Wrap
RUN
POWER
CPU FAULT
FORCED I/O
BATTERY LOW
Processor
Release
Indicates the LED is OFF.
COMM
Indicates the LED is ON.
Indicates the LED is FLASHING.
Status of LED does not matter.
The RUN LED on the SLC 5/01 processor is
actully labeled "PC RUN." Also, the SLC
5/01 processor does not have a COMM
LED.