TFA_No. 60.2531_Anl_12_21
BINGO – Radio-controlled alarm clock
• Avoid contact with skin, eyes and mucous membranes when handling
leaking batteries. In case of contact, immediately rinse the affected areas
with water and consult a doctor.
Important information on product safety!
• Do not expose the device to extreme temperatures, vibrations or shocks.
• Protect it from moisture.
5. Elements
A: Display:
A 1:
Time, seconds
A 2:
Day of the week
A 3:
Date
A 4:
Alarm time 1 (activated)
A 5:
Radio-controlled time symbol
A 6:
Temperature
A 7:
Alarm time 2
B: Buttons:
B 1:
SNOOZE/LIGHT button
B 2:
SET 1 button
B 3:
– button
B 4:
+ button
22
19.12.2021
11:16 Uhr
Seite 12
BINGO – Radio-controlled alarm clock
B 5:
SET 2 button
B 6:
AL 1 ON/OFF switch
B 7:
AL 2 ON/OFF switch
B 8:
AUTO LIGHT ON/OFF switch
B 9:
SET button
C: Housing:
C 1:
Battery compartment
C 2:
Color mark for the alarm time 1 ON / OFF
C 3:
Color mark for the alarm time 2 ON / OFF
C 4:
Light sensor
6. Getting started
• Open the battery compartment and insert the two batteries 1,5 V AA.
Make sure the polarities are correct.
• Close the battery compartment again.
• The device will alert you with a beep and all LCD segments will be dis-
played for a short moment.
• The clock will now scan the DCF frequency signal and the DCF symbol
will be flashing on the LCD. When the time code is received success-
fully after 3-8 minutes, the radio-controlled time, the date and the DCF
symbol are displayed steadily in the LCD.
• The DCF reception always takes place at 3:00 o'clock in the morning. If
the reception is not successfully received at 3:00 o'clock, it shall be held
further attempts at 4:00 and 5:00 o'clock.
23