Installation Of The Clima Micro Day/Night Fan Control; Operation Of The Clima Micro Day/Night Fan Control; Connecting Sensors Or Other Devices; Control And Set The Clima Micro Day/Night Fan Control - TechGrow Clima Micro Manual Del Usuario

1. Installation of the Clima Micro
Day/Night Fan Control
1. Mount the TechGrow Clima Micro Day/Night Fan
Control on the wall with the supplied mounting kit.
2. Ensure that the light sensor (the milk-colored cap on
the front) can detect light directly to enable
automatic switching between day and night mode.
3. Put the plug of the fan into the socket of the Clima
Micro Day/Night Fan Control.
4. Put the plug of the Clima Micro Day/Night Fan
Control into an electrical outlet.
5. Ready!
2. Operation of the Clima Micro
Day/Night Fan Control
The Clima Micro Day/Night Fan Control controls the
ventilation in your room. With this controller you can
run your fan at a different speed during the day and at
night. The controller responds to light thanks to the
built-in light sensor, which enables automatic switching
between day and night mode.
The Clima Micro Day/Night Fan Control has 3 rotary
knobs to adjust the day and night speed of your fan,
and to set the delay time.
3. Connecting sensors or other
devices
It is not possible to connect any sensors or other devices
to the Clima Micro Day/Night Fan Control. This
controller therefore measures neither the temperature
nor the air humidity or CO
regulates the fan speed.
4. Control and set the Clima Micro
Day/Night Fan Control

4.1 Fan speed day mode

After installing the Clima Micro Day/Night Fan Control
the fan starts to run (the fan must be on). Adjust the fan
speed "Day Fan Speed" (0% – 100%) by turning the left
knob.

4.2 Fan speed night mode

To adjust the fan speed for the nighttime, cover the light
sensor (for example with your hand) during adjustment.
____________________________________________________________________________________________________________________________
TechGrow | Innovative Growing Solutions
concentration, but only
2
Now set the desired fan speed "Night Fan Speed" (0% –
100%) by turning the right knob.

4.3 Delay time

You can set a delay time of 0 to 10 minutes for switching
between day and night mode. You set the desired delay
time by turning the middle knob "Delay Time".

5. Fuse replacement

If a short circuit occurs due to fan overload, the fuse will
blow. Even if the Clima Micro Day/Night Fan Control
does not operate at all, in the worst case, this could
indicate a blown fuse. To replace the fuse you have to
open the Clima Micro Day/Night Fan Control. Complete
the following steps:
1. Remove the plug from the socket.
2. Open the housing by unscrewing the 4 screws on
the back of the Clima Micro Day/Night Fan Control.
3. Locate the fuse and remove it.
4. Insert a new 5 amp fuse.
5. Screw the 4 screws to close the housing.
Your Clima Micro Day/Night Fan Control is ready for use
again.
7