Step 10
Carefully turn your unit over onto its front edges. Lay the
å
BACK (I) over your unit.
Make equal margins along all four edges of the BACK (I). Push
å
on opposite corners of your unit if needed to make it "square".
Fasten the BACK (I) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the UPRIGHTS (C and D).
NOTE: Perforations have been provided for access through
å
the BACK. Carefully cut out the holes needed.
Page 14
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
These holes must line up over
the UPRIGHTS (C and D).
419321
NAIL
(32 used in this step)
I
www.sauder.com/services
1N