Inateck FE2101 Manual De Instrucciones página 4

1. Press-button switch (take out hard disk with one press)
2. Reset switch (combined with SW1/SW2 switch to change working mode
of the enclosure)
3. USB3.1 Type C interface
4. Micro B 5V power supply interface
5. Logo Indicator (Light is on when the enclosure is connected to power)
6. DISK1 blue indicator (The indicator shines when hard disk 1 reads and
writes.)
7. DISK2 blue indicator, (The indicator shines when hard disk 2 reads and
writes.)
8. ERROR red indicator, (The light will be on when error on the disk is
detected)
9. Digital 1SATA interface
10. SW1/SW2 switch
11. Digital 2SATA interface
Hard drive installation steps
1. Extract hard disk mounting rack from aluminum case.
2. Lay the two hard disks into bracket.
3. Use screw to fix the hard disk and its bracket.
4. Connect to computer and adjust the mode.
5. Mount the aluminum case.
Way to Change the Combination of RAID
Step 1: In the state of power-on, put the SW1/SW2 to "OFF" and then press
RESET. When DISK1/2 flickers, release RESET button. （back to NO
RAID）
Step 2: According to the needed RAID, set SW1/SW2 and press RESET.
Release it when DISK1/2 indicator shines.
Cautions: You need to experience Step 1 when change RAID. Before you
use the product, please back up the data. Set the raid in accordance
with cross-references.
2