Safety Devices; Use According To Intended Purpose; Residual Risks; Safety Instructions - Mafell KSS 80 Ec/370 Manual De Instrucciones Original

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 56

2.7 Safety devices

Danger
These devices are required for the
machine's safe operation and may
not be removed or rendered
inoperative.
The machine is equipped with the following safety
devices:
- Upper stationary saw guard
- Lower retractable saw guard
- Large base plate
- Handles
- Riving knife / splitter
- Index mechanism and brake
- Hose connector

2.8 Use according to intended purpose

The MAFELL cross-cutting system KSS80Ec/370 is
exclusively suited for longitudinal and cross cutting of
solid wood.
Panel materials such as chip board, core board and
medium density fibre board can also be processed.
Use approved saw blades according to EN 847-1.
Any other use than described above is not
permissible. The manufacturer cannot be held liable
for any damage arising from such other use.
So as to use the machine as intended, comply with
the operating, maintenance and repair instructions
specified by Mafell.

2.9 Residual risks

Danger
Even if used in accordance with its
intended purpose and despite
conforming with the safety
instructions, residual risks caused
by the intended use will always
remain.
All manuals and user guides at all-guides.com
- Touching the saw blade in the vicinity of the
- Touching the part of the saw blade that protrudes
- Touching of turning parts from the side: saw blade,
- Machine backlash if the blade gets stuck in the
- Breakage of the saw blade and risk of the blade or
- Touching live parts with the housing open and the
- Hearing can be impaired when working for long
- Emission of harmful wood dusts during longer
3
General instructions:
- Children and adolescents must not operate this
- Never work without the protection devices
- When operating the machine outdoors, use of an
- Damaged cables or plugs must be immediately
- Avoid sharp bends in the cable. Especially when
-18-
starting aperture below the base plate.
below the workpiece when cutting.
clamping flange and flange screw.
workpiece.
pieces of the blade being hurled away.
mains plug not removed.
periods without ear protectors.
operation without extraction.

Safety instructions

Danger
Always observe the following safety
instructions and the safety
regulations applicable in the
respective country of use!
machine. This rule does not apply to young
persons receiving training and being supervised by
an expert.
prescribed for the respective operating sequence
and do not make any changes to the machine that
could impair safety.
earth-leakage circuit-breaker is recommended.
replaced.
transporting and storing the machine, do not wind
the cable around the machine.

Publicidad

Tabla de contenido
loading

Tabla de contenido