Cleaning Carpets; While Operating - Tennant EX-SC-716 Manual Del Operario

CLEANING CARPETS

1. Turn on Master switch (Figure 3).
FIG. 3
2. Press and hold in Carpet Cleaning button. Pull
machine towards you, 1.5m (4 ft) at a time. For
best cleaning results, lift machine handle slightly
while pulling backward. This transfers weight of
machine to the vacuum head for best water
recovery (Figure 4).
FIG. 4
3. At end of path, release the Carpet Cleaning button
and continue to pull machine towards you another
30 cm (1 ft) to pick up un--recovered spray. Push
down on handle and move machine to next area to
be cleaned. Overlap each path by 50 mm (2 in).
WARNING: Fire Or Explosion Hazard. Do Not
Pick Up Flammable Materials Or Reactive Metals.
EX- -SC- -716 (04- -10)
Home Find... Go To..

WHILE OPERATING

1. If necessary, adjust brush height to accommodate
type of carpet (See ADJUSTING BRUSH
HEIGHT).
2. Work away from wall outlet and power cord to
prevent cord damage.
3. Check for excessive foam buildup in recovery tank.
Use a recommended foam control solution to
prevent motor damage (Figure 5).
FIG. 5
ATTENTION: Do not allow foam to enter vacuum
screen. Damage to vacuum motor will result. This
damage is not covered by warranty.
4. If the brush or vacuum motor should stop, circuit
breaker may have tripped. Turn off machine,
unplug power cord and check for any obstructions.
Let motor cool and manually reset circuit breaker
button, located on bottom of switch box (Figure
6NO TAG).
FIG. 6
WARNING: Electrical Hazard. Unplug power
Cord Before Servicing Machine.
WARNING: Spinning Brush. Keep Hands
Away. Turn Off Power Before Working On Machine.
OPERATION
EN
7