Front Panel Leds; Side Panel - Cisco 200 Serie Guia De Inicio Rapido

• Unusually long access time:
Due to the spanning tree loop detection logic, adding new connections
might take 30 to 60 seconds for the affected interfaces and/or LAN to
become operational.
Features of the Cisco Small Business
4
Smart Switch
This section describes the exterior of the smart switches including ports,
LEDs, and connections.
Back Panel Ports
The Ethernet ports are located on the back panel of the switch.
RJ-45 Ethernet Ports—Use these ports to connect network devices, such
as computers, printers, and access points, to the switch. If your switch
supports PoE, ports 1-4 can provide PoE and ports 5-8 are standard
Ethernet ports.

Front Panel LEDs

The LEDs are located on the front of the switch.
System LED—(Green) Lights steady when the switch is powered on, and
flashes when booting, performing self tests, and acquiring an IP address. If
the LED flashes amber, the switch has detected a hardware failure.
LINK/ACT LED—(Green) Lights steady when a link between the
corresponding port and another device is detected. Flashes when the port
is passing traffic.

Side Panel

Power—The Power port is where you will connect the switch to power.
Returning the Device to the Factory
5
Default Settings
The 8-Port Smart Switch models does not have a Reset button. To return
the device to factory default settings, follow the instructions in the Cisco
Small Business Smart Switch Administration Guide.
8
All manuals and user guides at all-guides.com
200 Series 8-Port Smart Switches