Installation Instructions; Mounting Instructions - JUNO FLEX 12 Manual Del Usuario

Juno Flex 12
™
SAVE THESE INSTRUCTIONS

MOUNTING INSTRUCTIONS

Pendant Stem Mount (TF60 STEM)
1. Remove HOUSING from MOUNTING PLATE assembly.
2. Attach MOUNTING PLATE assembly to JUNCTION BOX (not
included) with JUNCTION BOX SCREWS (not included).
3. Connect TRANSFORMER INPUT LEAD WIRES to 120V electrical
supply wires. Connect white to white and black to black. Connect
green GROUND WIRE in accordance with NEC requirements.
4. Route TRANSFORMER SECONDARY LEAD WIRES through
HOUSING. Dress wires and replace HOUSING onto MOUNTING
PLATE and secure.
5. Route TRANSFORMER SECONDARY LEAD WIRES through
PENDANT STEM (not included) and attach PENDANT STEM to
HOUSING. Secure PENDANT STEM in place using PENDANT
STEM SET SCREWS.
6. Slide FEED CYLINDER top cap onto stem. Install and tighten FEED
CYLINDER THREADED BUSHING as shown.
7. Using FEED CYLINDER as a guide, shorten and strip
TRANSFORMER SECONDARY LEAD WIRES 5/8˝.
8. Insert tinned end of TRANSFORMER SECONDARY LEAD WIRE
under screw head as shown in Fig B. Firmly tighten screw.
Repeat step for other side.
9. Screw TOP CAP onto FEED CYLINDER.
1300 S. Wolf Road • Des Plaines, IL 60018 • Phone 800-323-5068 • Visit us at www.acuitybrands.com/juno-trac
©2017 Acuity Brands Lighting, Inc

INSTALLATION INSTRUCTIONS

LED-Compatible Transformers
Rev 3/17
Transformer Input
Lead Wires (2)
Transformer
Secondary
Lead Wires (2)
P6034
Junction Box Screws (2)
(not included)
Housing
Housing Screws (2)
Pendant Stem
Set Screws (2)
Pendant Stem
(not included)
Feed Cylinder
(not included)
Feed Cylinder
Threaded Bushing
Fig B
Top Cap
Junction Box
(not included)
Ground Wire
Mounting Plate
2 of 4