Toolshop 241-9934 Manual De Seguridad Y Operacion página 13

WORKING HINTS FOR YOUR DRILL
1. If your power tool becomes too hot set the speed to maximum and run no load
for 2-3 minutes to cool the motor.
2. When drilling in metal, only use HSS drill bits in good condition.
3. Where possible use a pilot hole before drilling a large diameter hole in the metal
material.
MAINTAIN TOOLS WITH CARE
Remove the plug from the socket before carrying out any adjustment, servicing
or maintenance.
Your power tool requires no additional lubrication or maintenance. There are no user
serviceable parts in your power tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always store your power tool in a dry
place. Keep the motor ventilation slots clean. Keep all working controls free of dust.
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
TROUBLESHOOTING
1 If your drill will not operate, check the power at the mains plug.
2 If the drill is not cutting properly, check the drill bit for sharpness, replace drill bit if
worn. Check that the drill is set to forward rotation for normal use.
3 If a fault can not be rectified return the drill to an authorized dealer for repair.
13