Nolan N62 Seguridad E Instrucciones página 8

INSTRUCTIONS FOR USE
• VISOR
1 DISASSEMBLY
1.1 Open the visor completely.
1.2 Press and hold the visor release button (A) down and slide the visor forward until it clicks (Fig. 1).
1.3 Free the visor hooks (B1 and B2) from their housing.
1.4 Follow the same steps on the other side of the helmet.
Attention: do not remove the visor mechanisms from the shell.
2 ASSEMBLY
2.1 Set the visor in open position by placing the visor hooks (B1 and B2) in line with the housings in
the visor mechanism (Fig. 2).
2.2 Insert hook B1 in the housing provided and press the visor against the shell in line with hook B2.
This will actuate the visor release button. (Fig. 2).
2.3 Slide the visor until the visor locks into place.
2.4 Follow the same steps on the other side of the helmet.
ATTENTION!
- After each assembly or disassembly procedure of the different parts, check that the visor mecha-
nism works properly by pulling the visor up and down; if necessary, repeat the above described
steps.
- If the visor pulling-up/-down mechanisms get damaged or malfunction, refer to a Nolan authori-
sed dealer.
• REMOVABLE INNER COMFORT PADDING
(only for versions with removable inner padding)
1 DISASSEMBLY
1.1 Open the chin strap (see instructions).
1.2 Unhook the left rear flap from the support fixed to the inner shell by slightly deforming the shell
sealing edge and slightly pulling the comfort padding in the helmet neck-ring area towards the
inside (Fig. 3). Follow the same steps to remove the central and right rear flap.
1.3 Unhook the left front flap from the support fixed to the inner shell by slightly puling the comfort
padding towards the inside of the helmet (Fig. 4). Follow the same steps to remove the central
and right front flap.
1.4 Remove the inner comfort padding from the helmet.
2 ASSEMBLY
2.1 Properly insert the comfort padding inside the helmet.
2.2 Hook the front fastening flaps to the support fixed to the inner shell by slightly pushing the liner
towards the outside of the helmet (Fig. 4).
2.3 Hook the rear fastening flaps of the inner comfort padding to the slots in the neck-ring area (Fig. 3).
To carry out this step, slightly deform the sealing edge of the shell and push until the fastenings
click. Take care to stretch the liner so that it adheres to the inner polystyrene.
2.4 Insert the right and left side flaps of the comfort padding by pushing them between the inner and
outer shells (Fig. 5).
ATTENTION!!!
- If your helmet is equipped with the D-Ring retention system, pull it down as indicated in
the attached D-Ring label.
- After each assembling or disassembling of the comfort padding, check the comfort by wearing the
helmet and, if necessary, repeat the steps described above.
- Remove the padding only when cleaning or washing is required.
8