Ritter RITOS BTL9000-20-S Manual De Instrucciones página 9

All manuals and user guides at all-guides.com
Switching the illuminants on and off
• The two toggle switches at the back of the reflector spot switch the illuminants on and off. The
sockets cannot be operated.
• Toggle switch 1: switches the centre illuminant
• Toggle switch 2: switches the two outer illuminants
Changing the illuminants
Pull the power plug from the socket. Wait at least 5 minutes before changing the energy-saving
lamps.
1. Unscrew the 4 screws in the corners of the transparent cover and remove the cover from the
fitting to access the energy-saving lamps.
2. Do note: only suitable for energy-saving lamps, use a max. 1 x 20W and 2 x 15W. Observe the
maximum base diameter (see specifications)
3. Undo the energy-saving lamps and screw the new ones into the holder. Make sure the
energy-saving lamps are correctly screwed into the holder.
4. Fit the cover and secure with the 4 screws. The reflector spot is again ready to be used
Setting the Floodlight Direction
Loosen the screws on the sides of the mounting brackets, adjust the floodlight direction, and then
retighten all screws.
Cleaning
• Disconnect and lock out the power supply to the floodlight. Allow the floodlight to cool down
sufficiently!
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent if required. Do not
use cleaners that contain abrasives or solvents.
• If required, the illuminant can be cleaned with a lint-free cloth moistened with ethyl alcohol.
ATTENTION! After cleaning the illuminant with ethyl alcohol, it must be allowed to air dry for at
least 20 minutes.
Maintenance
• If the lens is damaged it must be replaced immediately.
• Clean any dirt from the housing or the lens immediately, since it could cause overheating.
WEEE-reference of disposal
In accordance with European defaults used electrical and electronics devices may no
more be given to the unsorted waste. The symbol of the waste bin on wheels refers to the
necessity of separate collection.
Please help with environmental protection and see to it that this device is given to the for this
purpose designated systems of waste sorting if you do not use it any longer.
GUIDELINE 2012/19/EU of the EUROPEAN PARLIAMENT AND the COUNCIL of July 04th 2012
about electrical and electronics old devices.
GB
7