Axxes Viaxxes SAT Guia Del Usuario página 14

CHAPTER 1
INSTALLING THE UNIT
STEP 3 - CONNECTION TO THE CIGARETTE
LIGHTER SOCKET
Connect the cigarette lighter cable to the vehicle socket and make
sure:
- The plug is securely connected.
- The cable will not get in the driver's way.
NB: However, we recommend a connection to the vehicle power supply (see
next page).
All manuals and user guides at all-guides.com
26
CHAPTER 1
INSTALLING THE UNIT
STEP 3 - CONNECTING TO THE VEHICLE'S POWER
SUPPLY (RECOMMENDED METHOD)
This installation should be carried out by a qualified vehicle electrician.
Axxès cannot be held liable in the event of any damage or an incorrect
installation.
1. Use the cable supplied (part C). Make sure the cable is long enough to reach the
power supply, then remove the lighter plug and any excess cable.
2. Locate the connection points in the vehicle using the diagram below. The black
ignition signal wire should be connected to the vehicle ignition.
3. Before connecting the cables to the vehicle, install a 5-amp fuse
(not supplied) in series with the power wires (red and black wires).
If the vehicle's power supply is already protected, this step is not necessary.
4. Finally, connect each wire to the connection points you have identified (vehicle
power, ignition and earth).
RED +12V / +24V Power
BLACK +12V / +24V Ignition
WHITE
27
Earth