Kathrein UFO 372/TP Manual Del Usuario página 19

1.7 Selecting the output level
The output level is selected using the "<" and ">" buttons.
I 1236 MHz
27.500 MS/s
Outp. S21
6.900 MS/s
Main menu
The output signal rate can be adjusted in 40 steps from level maximum ("0") to minimum ("-40") using the output channel
sub-menu.
Pressing the "Sub-menu" button
The output level is selected using the "<" and ">" buttons and adjusted using the "+" and "-" buttons.
1.8 Switching output on/off
The output channel unit is selected using the "<" and ">" buttons.
I 1236 MHz
27.500 MS/s
Outp.
* S21
6.900 MS/s
Main menu (output I switched off)
The output can be switched on and off using the output channel sub-menu.
The following settings are available: on or off
Pressing the "Sub-menu" button
The output is selected using the "<" and ">" buttons and adjusted using the "+" and "-" buttons.
When the output is switched off an indicator (*) is shown in the main menu, on the left beside the output channel.
If any channel unit (I or II) is not used, its output signal must be switched off.
1.9 Selecting the output symbol rate
The output symbol rate is selected using the "<" and ">" buttons.
I 1236 MHz
27.500 MS/s
Outp. S21
6.900 MS/s
Main menu
The output symbol rate can be adjusted continuously from 2.275 MS/s to 7.150 MS/s in 0.001 MS/s steps using the "+" and "-"
buttons.
The digits can also be entered individually to a resolution of 0.001 MS/s:
• Press the "Change setting mode" button
• The fi rst digit fl ashes and can be input directly using the buttons on the keyboard
• After the fi rst digit has been input, the second fl ashes, and so on
• To make a correction, press the "Back" button to skip one place to the left
• After the last digit has been set, press the "Change setting mode" button
All manuals and user guides at all-guides.com
TP
3/4 QPSK
306.00 MHz
256 QAM
activates the sub-menu; pressing the "Sub-menu" button again deactivates it.
TP
3/4 QPSK
306.00 MHz
256 QAM
activates the sub-menu; pressing the "Sub-menu" button again deactivates it.
TP
3/4 QPSK
306.00 MHz
256 QAM
(starts mode)
** UFO 372TP-I
Frequency 306.00
Level 0
Output on
"Output frequency" sub-menu
** UFO 372TP-I
Frequency 306.00
Level 0
Output off
"Output channel" sub-menu
to end the mode
**
MHz
**
MHz